9-5 SE Wagon (9600) V6-3.0L Turbo (B308) (2001)
/v6-3.0l_turbo_(b308)/Page-1997019.png)
11. Detach the rear section of the backrest upholstery fabric by removing the upholstery retaining strip and folding the fabric to one side.
12. Remove the upholstery retaining strip along the edge at the rear of the backrest frame.
13
Unplug the side airbag's connector.
14
Remove the side airbag, 3 nuts.
15
Lift out the side airbag.
Replacement
Fit In Reverse Order.
Check the SRS and control module, using the Tech2 instrument, as follows:
With the ignition switch in the ON position, plug the Tech2 instrument into the data link connector under the dashboard. Clear any diagnostic trouble
codes that may be present.
Switch off the ignition and switch it on again. Wait at least 10 minutes with the ignition switched on.
Check whether a diagnostic trouble code is displayed:
If a diagnostic trouble code is displayed:
Carry out fault diagnosis according to the instructions in the diagnostic trouble codes.
If no diagnostic trouble code is displayed:
