9-5 Sedan (9600) L4-2.3L Turbo (B235) (2000)
4
Start the engine. Depress the accelerator and then check if any new diagnostic trouble codes have been generated. Rectify and erase any diagnostic
trouble codes.
5
Turn the ignition OFF and wait 10 seconds. Check that the throttle is not in limp-home mode as follows:
a
4-cyl.: Remove the upper engine cover.
b
4-cyl.: Remove the cover from the throttle body.
c
Turn the pedal arm clockwise. The top illustration shows 4-cyl and the bottom V6.
d
Check that the throttle arm does not make the reciprocal movement when the pedal arm is turned.
e
To reset limp-home mode, if necessary see WIS - Engine - Trionic T7 - Adjustment/replacement - Resetting triggered limp-home solenoid.
f
4-cyl.: Fit the cover over the throttle body and the upper engine cover.
Marking the campaign plate
After the car has been inspected and/or modified mark the campaign plate in box C4, using a numeral "8" (Saab Special Tool P/N 02 97 713). If needed,
order this special tool directly from Kent-Moore at 1-800-345-2233.
Warranty/time information
See separate information.