9-5 Sport Wagon (9600) L4-2.3L Turbo (B235) (2003)
/l4-2.3l_turbo_(b235)/Page-910003.png)
5. Measure the width of the Plastigauge strip using the scale that is printed on the packaging to measure the clearance. One side of the packaging
gives measurements in mm and the other in 1000ths of inches. Measure the strip at its widest point. Do not touch the strip with your fingers. See
Crankshaft regarding dimensions.
Big-end bearings
Before the bearing clearance is checked in connection with fitting of new bearings, the crankshaft journals ovality and taper must be checked.
The clearances are checked with Plastigauge, part number 30 06 558, available in three dimensions.
Type PG-1 (green) must be used.
Important: When using the Plastigauge to measure play, be careful not to get any in the oil holes.
Measure ovality with a micrometer in two positions 90 degrees from each other.
Clearance can be checked with a Plastigauge as follows:
1. Clean the parts to be measured so that they are dry and free from oil and dirt. Place a strip of Plastigauge along the shaft.
