9-5 Sport Wagon (9600) L4-2.3L Turbo (B235) (2003)
/l4-2.3l_turbo_(b235)/Page-1329013.png)
-
Speed (bus from MIU) used as substitute value.
-
Cruise control blocked.
Speed, Lead From ABS
Speed, Lead From ABS
The ABS control module sends a speed signal to pin 64 on the Trionic T7 control module. The signal is a square wave that varies between 0 V and B+
29 times per wheel revolution. This speed signal is used to:
-
prevent adaptation of idle speed control when the car is moving.
-
on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel
shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.
-
activate speed limitation, which is achieved by limiting the maximum air mass/combustion at 240 km/h.
Diagnostics
-
If the speed signal is missing, diagnostic trouble code P0502 will be generated.
-
If the speed value is implausible, diagnostic trouble code P0501 will be generated.
System reaction to a fault
