9-5 Sport Wagon (9600) L4-2.3L Turbo (B235) (2003)
/l4-2.3l_turbo_(b235)/Page-1822004.png)
2. Make sure that the intermediate shaft is clean and then align the intermediate shaft in the tool.
IMPORTANT: Fit the intermediate shaft in the gearbox until about 20 mm remains and extract the tool before the shaft's sealing surface
reaches the shaft seal.
3. Push in the rest of the shaft.
4. Guide the support bearing bracket onto the upper locating pin and then tighten the bearing bracket.
5. Make sure that the adjuster sleeves in the generator bracket is tapped out approximately 1 mm to facilitate fitting. Then fit the two generator
retaining bolts and tighten the lower one.
6. Connect the generator cables.
7. Tilt out the MacPherson strut and attach the drive shaft to the intermediate shaft until the circlip snaps in place. Lubricate the splines with
universal paste 87 81 684, see Summary of lubricants and sealants.
