9-5 Sport Wagon (9600) L4-2.3L Turbo (B235) (2003)
/l4-2.3l_turbo_(b235)/Page-4020004.png)
2. Remove loose particles, dirt and remnants of the plastic moulding from the metal flange, using a vacuum cleaner.
3. Make good any damage to the paintwork.
-
Scrape off any loose flakes of paint with a knife.
-
Wash clean with Terosans Rengorare FL (Cleaner).
-
Apply primer. Use Standox 1K Fullprimer.
-
Apply the finish coat.
IMPORTANT: The paintwork must be flawless to prevent the onset of corrosion. In addition, an imperfect paintwork repair could
result in the layers of paint separating under the bead of adhesive.
4. If there is no old adhesive, or if the adhesive is not intact, primer must be applied to the painted surfaces with which the adhesive will be in
contact. Use Betaprime 5061 (green) on any touched-up surfaces. Do not use body primer on old, well-cohered adhesive.
IMPORTANT: Never apply primer to the old adhesive. Only use primer if there is no old adhesive.
5. Close the tailgate.
6. Place the window inside up on a stand to provide an appropriate work height.
NOTE: Do not remove the pieces of tape from the spacers of the new window. They protect against squeaks.
7. Carefully wash the edges of the window with Betawipe 3300. Carefully wipe the edges using the wet cleaning cloth. Dry with the dry cleaning
cloth provided in the adhesive kit. Avoid touching the cleaned surface.
IMPORTANT: Do not allow the cleaning agent to dry naturally as it may leave traces of grease on the glass. Always dry with clean,
lint-free rags and refold them frequently.
8. Apply Betaprime 5061 (green) to the cleaned surface. Do not apply glass primer closer than 2 mm from the antenna connection. Allow the primer
to dry for 10 minutes.
9. Avoid touching the primed surface.
NOTE: If the rear window is to be secured with tape after being fitted, make sure the roof has been cleaned before starting to fit the rear window.
10. Apply the adhesive as follows:
