9-5 Sport Wagon (9600) V6-3.0L Turbo (B308) (2003)
/v6-3.0l_turbo_(b308)/Page-2504011.png)
6.
Position the air distribution housing. Carefully pass through the control rod to the rear air distribution valve. Tighten the screws.
Tightening torque 1.4 Nm (1 lbf ft)
7.
If necessary, raise the stepping motor linkage in the air distribution housing so that the two centre air outlets on the top side open fully.
8.
Transfer the linkage gear for the rear air distribution valve from the old to the new heat exchanger housing. Make sure the markings on the gears
are aligned, then turn the linkage gear to the stop. Insert the control rod and lock the clip.
