9-5 Sport Wagon (9600) V6-3.0L Turbo (B308) (2003)
/v6-3.0l_turbo_(b308)/Page-2544023.png)
12.
Fit the upper section of the new control rod in its clip.
13.
Wind up the linkage to the stepping motor in the air distributor housing to the upper stop.
14.
Fit the stepping motor and its 2 screws to the air distributor housing.
15.
Locate the fan housing into its position and fit the screws to the cabin fan housing and fit the 2 clips.
Tightening torque 1.4 Nm (1 lbf-ft.)
16.
Up to M04 inclusive: Fit the fan control module and route the wiring up under the clasp. Where applicable, fit the water barrier.
Where appropriate, fit the temperature sensor connector to the plate and fit the plate to the heat exchanger housing. Make sure to guide the rubber
grommet into the plate.
