9-5 Sport Wagon (9600) V6-3.0L Turbo (B308) (2003)
/v6-3.0l_turbo_(b308)/Page-4000006.png)
17. Hook the wire ends through the eyes of the chisel and bend the ends so that they do not come out.
18. Pull the chisel back through the glue joint into the passenger compartment. Pull in the wires about 0.7 m.
WARNING: Ensure that the wire is not connected to the battery terminals if the cover is removed, otherwise there is a risk of
short-circuit/fire.
19. Unhook the cutting wires from the chisel. Straighten the wire ends so that they are at an obtuse angle. Put the chisel aside.
20. Place the cutting wire around the windscreen. Ensure that it lies around all corners. Pull in the wire and check that it lies between the metal and the
windscreen.
21. In some cases, the glue joint may be so far down that there is no metal edge to place the cutting wire against (it then slides under the metal edge
and cannot cut the glue joint). If that is the case, make four holders to keep the wire in place against the glue joint. Press the holders into the glue
joint and place the wire in the holders. Then pull the wire into the car and continue as follows.
