saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

General Information|Page 9029 > < General Information|Page 9027
Page 34
background image

Trip Computer Functions SID 1/SID 2

Outside temperature

The current outside temperature will be shown in the SID display if the TEMP function is selected or the temperature warning function is activated. The
outside temperature will then be shown automatically. Information on the outside temperature comes from the sensor in the front spoiler.
A temperature warning function is built into the SID unit and works as follows:
If the temperature falls from a higher temperature down to +3 °C (37 °F) or rises from a lower temperature to -3 °C (26 °F), the outside temperature is
automatically displayed irrespective of the SID unit display setting.
This display remains until another function is selected.
To avoid the effect of radiant heat, the temperature sensor reading is updated differently depending on whether the outside temperature is rising or
falling, and is speed-dependent.

The reading is updated as follows:

^

+1 °C (1.8 °F) every 6 minutes at speeds below 30 km/h.

^

+1 °C (1.8 °F) every 30 seconds at speeds above 30 km/h.

^

-1 °C (1.8 °F) every 2.5 seconds.

If the engine is turned oft, the current outside temperature reading is stored in the SID. The SID unit calculates for how long the engine has been
switched off. When the ignition is turned on again, the SID unit displays the stored outside temperature reading from ignition OFF if the time since
turning off the engine is:

^

less than 12 minutes

If the engine has been turned off for more than 12 minutes, the current outside temperature reading from the sensor is shown.
Information on the outside temperature is sent as bus information, unit °C/°F(-40 to +50 °C), (-40 to 122 °F).

DTE (Distance On Remaining Fuel)

To calculate how far the car will run on the fuel remaining in the tank, the SID unit uses information on:

^

Fuel level, unit litres (bus information from MIU).

^

Odometer reading, unit km (bus information from MIU).

^

Fuel consumed since starting, unit ml (bus information from Trionic).

^

Coolant temperature, unit °C (bus information from Trionic).

The calculated value is updated every 16 seconds. To avoid rapid changes in the value, no update is carried cut when starting from cold or if car speed is

General Information|Page 9029 > < General Information|Page 9027