9-5 Wagon (9600) L4-2.3L Turbo (B235) (1999)
^
Turn the ignition switch to ON.
^
Read status: front lamp broken.
^
The tester should show status: NO.
Test results OK?
YES
^
Go to point 2.
NO
^
Check the lead between terminal 9 of the relay holder and pin 23 of the control module for a short-circuit to ground, and repair or replace it.
^
Go to point 3.
2. Check the control module signal input (contd.)
^
Connect a jumper lead between terminal 9 of the relay holder and a good grounding point.
^
Read status: front lamp broken.
^
The tester should show status; YES.
Test results OK?
YES
^
Replace: front lamp filament monitor.
^
Go to point 3.
NO
^
Check the lead between terminal 9 of the relay holder and pin 23 of the control module for a short-circuit to ground, and repair or replace it.
^
Go to point 3.
3. Final check
^
Clear the diagnostic trouble codes in all systems.