9-5 Wagon (9600) L4-2.3L Turbo (B235) (1999)
1. Fit the pump.
2. Turn the axle to the correct position in relation to the groove in the camshaft. Fit and lubricate the O-rings and loosely tighten the banjo nipple. Fit
and loosely tighten the three retaining bolts.
3. Tighten the banjo nipple.
Tightening torque: 24 Nm (18 ft. lbs.)
4. Tighten the pump retaining bolts, firstly the two in the cylinder head then the bolt in the stay.
Tightening torque: 24 Nm (18 ft. lbs.)
5. Connect the vacuum hose.
6. Connect the electrical connector for the ignition discharge module.
7. Wipe away any oil.
NOTE: Check the O-ring on the throttle body, replace if required. To facilitate fitting, a thin layer of Vaseline (part no. 300 66 65) can be applied
to the O-ring.