9-5 Wagon (9600) L4-2.3L Turbo (B235) (1999)
/l4-2.3l_turbo_(b235)/Page-1142019.png)
Diagnostics Communication
ABS and SRS
The two Systems which are not connected to a bus, ABS and SRS, are each connected to pin 8 of the data link connector by their own communications
lead.
The diagnostic tool communicates digitally and serially with the selected system. Digital means that the voltage difference between the lead and ground
has only two values, in this case roughly 0 V and B+. The information is coded so that different combinations of 0 V and B+ pulses have different
meanings, e.g. whether the SRS or ABS is to be called.
Serial means that the information is sent in "packets" which are transmitted one after the other in rapid succession.
Diagnostics
If none of the systems can be contacted, the fault may be either in the car or the diagnostic tool. If the diagnostic tool can contact one of the systems
concerned in another car, then the fault is in the car.
In that case, first check that the control module is awake. The ABS and SRS warning lamps are tested by the control module as soon as the ignition is
switched on. If the control module is awake, then the fault is probably in the lead between the data link connector and the control module.
Other Systems
