9-5 Wagon (9600) L4-2.3L Turbo (B235) (1999)
/l4-2.3l_turbo_(b235)/Page-1765006.png)
5. Remove the tape. Remove the knob from the carrier by using a small screwdriver to press in the three plastic lugs on the carrier (located under the
numbers 1, 5 and 4 on the knob).
Note the steel spring under the knob.
IMPORTANT: A gear lever knob which has been removed must not be refitted but replaced with a new one.
To Fit
1. Check that the ball socket ring is on the gear lever.
2. Insert the spring into the carrier.
3. Check that the stop lug is turned to the right when the numbers on the knob are correctly positioned and then press the knob onto the carrier.
4. Check that the gaiter is on the carrier.
5. Make sure that the gate positions marked on the knob and the carrier stop lug are correctly positioned in relation to the bearing hole at the bottom
of the gear lever (so that the gate position markings are correctly positioned in the car). Fit the knob loosely on the lever so that it fastens in the
splines.
6. Place the gear lever in a vice. Tap the knob with your hand or a light rubber hammer until the stop lug on the carrier is no more than 0-0.5 mm
