9-7X L6-4.2L (2008)
2. Position the center console to the vehicle.
3. Adjust the parking brake to the full-up, or fully engaged position.
4. Connect the electrical connectors as necessary.
5. Lower the rear of the console and slide the console forward into position.
6. Ensure that the 2 retaining ears on the front extensions of the console are fully engaged to the lower instrument panel (I/P).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
7. Install the center console retaining screws.
Tighten the screws to 2.5 Nm (22 in. lbs.).
8. Install the console storage compartment. Refer to Front Floor Console Compartment Replacement (See: Front Floor Console Compartment
Replacement).
9. Install the center console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (See: Console Shift Lever Bezel Replacement).
10. Install the floor shift control knob. Refer to Floor Shift Control Knob Replacement (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Shifter A/T/Service and Repair/Floor Shift Control Knob Replacement).
11. Install the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement (See: Powertrain Management/Ignition
System/Sensors and Switches - Ignition System/Ignition Switch/Ignition Switch Lock Cylinder/Service and Repair/Removal and Replacement).
12. Remove the blocks from the vehicle.
