9-7X L6-4.2L (2008)
5. Push the garnish molding into the liftgate in order to fully seat the retaining clips.
6. Close the liftgate.
Body Side Rear Window Garnish Molding Replacement
Body Side Rear Window Garnish Molding Replacement
Removal Procedure
1. Remove the bolt that retains the seat belt upper anchor to the body.
2. Remove the garnish molding from the vehicle.
Installation Procedure
1. Install the garnish molding to the vehicle.
2. Install the seat belt retractor to the body.
Notice: Refer to Fastener Notice.
3. Install the bolt that retains the seat belt anchor to the body.
Tighten the anchor bolt to 70 Nm (52 ft. lbs.).
Center Pillar Garnish Molding Replacement
Center Pillar Garnish Molding Replacement
Removal Procedure
1. Remove the front and rear door sill plates. Refer to Front Side Door Sill Plate Replacement (See: Scuff Plate/Service and Repair/Front Side Door
Sill Plate Replacement) and Rear Side Door Sill Plate Replacement (See: Scuff Plate/Service and Repair/Rear Side Door Sill Plate Replacement).
2. Move the seat to a forward position.
3. Partially remove the door opening weatherstrip from the door opening where it interferes with molding removal.
4. Release the 4 retaining clips that attach the garnish molding to the center pillar.
5. Disconnect the electrical connector from the temperature sensor, if equipped.