9-7X L6-4.2L (2008)
Important: Use care when installing the pad so the spreader springs are not excessively deformed.
2. Install the inboard brake pad.
Important: Use care when installing the pad so the spreader springs are not excessively deformed.
3. Install the outboard brake pad.
4. Rotate the brake caliper down into position.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
5. Install the lower brake caliper guide pin bolt.
Tighten the brake caliper guide pin bolt to 42 Nm (31 ft. lbs.).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
8. Fill the brake master cylinder reservoir. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master Cylinder/Service and
Repair/Procedures/Master Cylinder Reservoir Filling).
Caution: Refer to Firm Brake Pedal Caution.
9. Pump the brake pedal slowly and firmly to seat the brake pads.
10. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing).
