9-7X L6-4.2L (2008)
1. If the brake caliper guide pin is to be reused, clean the brake caliper guide pin using denatured alcohol, or equivalent.
2. Dry the brake caliper guide pin using non-lubricated, filtered air.
3. Apply high temperature silicone brake lubricant to the brake caliper guide pin. DO NOT apply lubricant to the brake pad hardware.
4. Install the front brake caliper to the bracket.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
Important: Tighten the leading bolt, closest to the bleed screw, first.
5. Install the front brake caliper guide pins bolts.
Tighten the bolts to 42 Nm (31 ft. lbs.).
Important: DO NOT reuse the metal/copper gaskets. Use only new copper gaskets.
6. Install the NEW copper gaskets to the front brake hose fitting.
7. Install the front brake hose fitting bolt and gaskets.
Tighten the bolt to 40 Nm (30 ft. lbs.).
