9-7X L6-4.2L (2008)
4. Install the camshaft caps and bolts.
Tighten the camshaft cap bolts to 12 Nm (106 in. lbs.).
5. Remove the J 44221.
6. Carefully move the sprockets back onto the camshafts and remove the J 44222.
7. Install the intake camshaft sprocket washer and bolt, and the exhaust camshaft actuator bolt.
*
Tighten the intake camshaft sprocket bolt the first pass to 20 Nm (15 ft. lbs.).
*
Use the J 36660-A to tighten the intake camshaft sprocket bolt the final pass an additional 100 degrees.
*
Tighten the exhaust camshaft actuator bolt the first pass to 25 Nm (18 ft. lbs.).
*
Use the J 36660-A to tighten the exhaust camshaft actuator bolt a final pass an additional 135 degrees.
8. Install the camshaft cover. Refer to Camshaft Cover Replacement (See: Cylinder Head Assembly/Valve Cover/Service and Repair).