9-7X L6-4.2L (2008)
Important: If relieving the fuel pressure for the fuel pressure gage installation and removal, it is NOT necessary to proceed with the
following steps.
12. Disconnect the CH-48027-2 (2) from the CH-48027-3 (4).
13. Disconnect the CH-48027-3 (4) from the J 42242.
14. Disconnect the J 42242 from the fuel rail service port.
15. Remove the shop towel from around the fuel rail service port, and place in an approved gasoline container.
16. Install the fuel rail service port cap.
17. Install the engine cover, if required.
18. Tighten the fuel fill cap.
