9-7X L6-4.2L (2008)
Notice: Refer to Fastener Notice.
3. Connect the evaporator tube to the evaporator (5).
Tighten the nut to 28 Nm (21 ft. lbs.).
4. Connect the auxiliary evaporator tube to the auxiliary piping.
Tighten the nut to 28 Nm (21 ft. lbs.).
5. Connect the evaporator tube to the condenser.
Tighten the nut to 28 Nm (21 ft. lbs.).
6. Install the coolant recovery tank. Refer to Coolant Recovery Reservoir Replacement (See: Engine, Cooling and Exhaust/Cooling System/Coolant
Reservoir/Service and Repair/Coolant Recovery Reservoir Replacement).
7. Install the washer solvent container. Refer to Windshield Washer Solvent Container Replacement (See: Wiper and Washer Systems/Windshield
Washer Reservoir/Service and Repair).
8. Install the nuts (1, 2) retaining the evaporator tube to the fender.
Tighten the nuts to 28 Nm (21 ft. lbs.).
9. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging (See: Service and Repair/Refrigerant Recovery and
Recharging).
10. Leak test the fittings of the components using the J 39400-A.
