9-7X L6-4.2L (2008)
1. Install the EVAP/fuel hose/pipe assembly (2) into the clip at the rear of the transmission.
2. Position the fuel EVAP/fuel hose/pipe assembly against the transmission and install the retaining bolt (3) through the EVAP/fuel hose/pipe
assembly strap into the transmission.
Tighten the bolt to 3.75 Nm (33 in. lbs.).
3. Raise the transmission to the normal installed position.
4. Install the transmission support. Refer to Transmission Support Replacement (See: Body and Frame/Frame/Cross-Member/Service and
Repair/Transmission Support Replacement).
5. Install the transfer case. Refer to Transfer Case Assembly Replacement (See: Transmission and Drivetrain/Transfer Case/Service and
Repair/Removal and Replacement/NVG 126-NP4 - Transfer Case/Transfer Case Assembly Replacement).
9. Lower the vehicle.
10. Connect the EVAP purge pipe (1) to the EVAP canister purge valve.
11. Connect the integral clip (2) to the wire harness bracket.
12. Connect the fuel feed pipe (3) to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service (See: Fuel Line Coupler/Service and
Repair/Metal Collar Quick Connect Fitting Service).