9-7X L6-4.2L (2008)
13. Connect the engine coolant temperature sensor electrical connector (1).
14. Install the PCM (1) onto the studs (5).
15. Install the PCM retaining bolts (3).
Tighten the bolts to 8 Nm (71 in. lbs.).
16. Install the PCM retaining nuts (6).
Tighten the nuts to 8 Nm (71 in. lbs.).
17. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
18. Inspect for leaks using the following procedure:
1. Turn ON the ignition, with the engine OFF for 2 seconds.
2. Turn OFF the ignition, for 10 seconds.
3. Turn ON the ignition, with the engine OFF.
4. Inspect for fuel leaks.
19. Install the fuel tank shield, if equipped. Refer to Fuel Tank Shield Replacement (See: Fuel Tank/Fuel Tank Shield/Service and Repair).
