9-7X L6-4.2L (2008)
4. Connect the chassis fuel feed pipe (1) to the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Line Coupler/Service and
Repair/Plastic Collar Quick Connect Fitting Service).
5. Connect the chassis EVAP purge pipe (2) to the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Line Coupler/Service
and Repair/Plastic Collar Quick Connect Fitting Service).
6. Install the EVAP/fuel hose/pipe assembly (4) to the fuel pipe clip at the rear of the engine.
7. Use the following procedure with 2WD:
1. Install the EVAP/fuel hose/pipe assembly into the clip (1) at the rear of the transmission.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Position the EVAP/fuel hose/pipe assembly against the transmission and install the retaining bolt (3) through the EVAP/fuel hose/pipe
assembly strap into the transmission.
Tighten the bolt to 3.75 Nm (33 in. lbs.).
3. Raise the transmission to the normal installed position.
4. Install the transmission support. Refer to Transmission Support Replacement (See: Body and Frame/Frame/Cross-Member/Service and
Repair/Transmission Support Replacement).
8. Use the following procedure with 4WD:
