9-7X L6-4.2L (2008)
Body Control Module: Service and Repair
Body Control Module Replacement
Body Control Module Replacement
Removal Procedure
Important:
*
The ignition switch should be in the OFF position when connecting or disconnecting the connectors to the body control module (BCM).
*
Always disconnect the 40-way body wiring extension FIRST, the 32-way tan connector SECOND and the 24-way gray electrical
connector LAST.
*
Always connect the 24-way gray electrical connector FIRST, the 32-way tan connector SECOND and the 40-way body wiring extension
LAST.
*
The BCM can set DTCs with the ignition switch in the OFF position. The BCM has battery run down protection for the courtesy lamp
circuit. The BCM battery run down protection cannot detect shorts on inputs or other circuits which the BCM does not control. Use the
scan tool in order to activate the POWER DOWN NOW mode. Use the POWER DOWN NOW mode in order to check for current draws
on circuits that are not controlled by the BCM, or controlled by the battery run down protection system.
*
Do not touch the exposed electrical contacts of the body wiring extension. Do not open the BCM housing. The module does not have any
serviceable components. The module may be replaced only as an assembly.
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair).
2. Position the left hand second seat to a cargo position.
3. Remove the rear electrical center cover.
4. Press down and hold the locking tab (1).
5. Disengage the sliding latch retaining the BCM to the rear electrical center.
Slide the latch inboard until fully extended, approximately 40 mm (1.6 in).
