9-7X L6-4.2L (2008)
Intake Air Temperature Sensor: Service and Repair
Mass Airflow Sensor/Intake Air Temperature Sensor Replacement
Removal Procedure
Important: Use care when handling the mass air flow/intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage
the honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and
lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation.
1. Disconnect the engine harness electrical connector (5) from the MAF/IAT sensor.
2. Remove the MAF/IAT sensor screws.
3. Remove the MAF/IAT sensor.
Installation Procedure
