9-7X L6-4.2L (2008)
8. Remove the negative battery cable ground terminal bolt (3) from the engine block.
9. Remove the negative battery cable ground from the engine block.
10. Cut the tape wrapped around the conduit and remove the negative battery cable.
Installation Procedure
Important:
*
The negative battery cable must not be connected to the battery prior to the installation of the engine harness ground terminal to the
engine block.
*
The negative battery cable must not be connected to the battery prior to the installation of the instrument panel harness and the engine
harness to the powertrain control module.
1. Install the negative battery cable and re-tape the conduit.
2. Position the negative battery cable ground to the engine block.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
