9-7X L6-4.2L (2008)
5. Install the spacer plate to transmission case gasket and the spacer plate to valve body gasket to the spacer plate. Use J 36850 in order to retain the
gaskets to the spacer plate.
*
The case gasket is identified by a C.
Be sure to place the case gasket on the transmission case side of the spacer plate.
*
The valve body gasket is identified by a V.
Be sure to place the valve body gasket on the valve body side of the spacer plate.
6. Ensure that the solenoid screens (1, 2) are in place on the spacer plate.
7. Place the checkball (3) on the spacer plate in the location shown.
8. Place the 3-4 accumulator spring (4) on the spacer plate.
9. Install the spacer plate and related components to the transmission.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
10. Install the spacer plate support and the spacer plate support retaining bolts.
Tighten the spacer plate support retaining bolts to 11 Nm (97 in. lbs.).
11. After installing the spacer plate support (2), look through the hole in the spacer plate to ensure that the checkball (1) has remained in the proper
location.
