9-7X L6-4.2L (2008)
3. Slide the J 43909 into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909 and drive the new
seal into the seal bore until it is seated at the bottom of the bore.
4. Install the PNP switch. Refer to Park/Neutral Position Switch Replacement (See: Sensors and Switches - A/T/Transmission Position
Switch/Sensor/Service and Repair).
5. Lower the vehicle.
6. Fill the transmission to the proper level with DEXRON(R) VI transmission fluid. Refer to Transmission Fluid Check (See: Testing and
Inspection/Component Tests and General Diagnostics/Transmission Fluid Check).
