9-7X V8-5.3L (2005)
3. Install the EN-46999-1 (1) to the manifold.
4. Notice: Refer to Fastener Notice in Service Precautions.
Install 2 of the manifold bolts (2) to the EN-46999-1.
Tighten the bolts to 25 Nm (18 ft. lbs.).
5. Connect the air out hose (2) of the EN-46999 (5) to the EN-46999-1 (1). Verify the air supply switch (4) is in the off position.
6. Connect the air in hose (6) of the EN-46999 (5) to a shop air source.
7. Connect the 12 volt power supply connectors (7) of the EN-46999 (5) to a 12 volt power supply. Verify the Power light (8) on the tool is
illuminated. If the light on the tool is not illuminated when connected to a 12 volt power supply, test and/or replace the 3 amp fuse.
8. Connect the EN-46999-5 power cable (3) to the electrical connector of the manifold.
