9-7X V8-5.3L (2005)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
1. Install the sight shield ball stud, if required.
Tighten the stud to 5 Nm (44 in. lbs.).
2. Position the sight shield retainer to the intake manifold and install the bolts, if required.
Tighten the bolts to 3 Nm (26 in. lbs.).
Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector.
Loss of engine performance or engine damage may result.
3. Install the sight shield to the sight shield retainer.
4. Seat the sight shield onto the ball stud and press down over the stud in order to secure the sight shield.
5. Tighten intake manifold sight shield wing nut until snug.
