9-7X V8-5.3L (2005)
3. Install the crankshaft front oil seal onto the J 41478 guide.
4. Install J 41478 threaded rod with nut, washer, guide, and oil seal into the end of the crankshaft.
5. Use J 41478 in order to install the oil seal into the cover bore:
1. Use a wrench and hold the hex on the installer bolt.
2. Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
3. Remove J 41478.
4. Inspect the oil seal for proper installation.
The oil seal should be installed evenly and completely into the front cover bore.
6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement (See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft
Pulley/Service and Repair).
7. Install the radiator. Refer to Radiator Replacement (LL8) (See: Cooling System/Radiator/Service and Repair)Radiator Replacement (LH6) (See:
Cooling System/Radiator/Service and Repair).
