9-7X V8-6.0L (2008)
2. Install the 6 push-pins that retain the seat back pad to the seat back frame.
3. Partially install the seat cover.
4. Install the 3 hog-rings to the reinforcement bar.
5. Install the seat cover the remainder of the way.
6. Engage the seat cover to the hook and loop retaining strips on the seat back pad.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
7. Install the screw that retains the rear seat back release latch bezel to the rear seat back.
Tighten the rear seat back release latch bezel screw to 3 Nm (26 in. lbs.).
8. Install the 3 push-pins at the bottom of the rear seat back.
9. Engage the hook and loop retaining strips at the bottom of the rear seat back.
10. Starting at either corner, engage the J-strips at the bottom of the rear seat back.
