9-7X V8-6.0L (2008)
Alignment: Specifications
Trim Height Specifications
Trim Height Specifications
Trim height must be verified and adjusted before aligning the vehicle.
Z Height Measurement
All ............................................................................................................................................................................... 53 mm (2.09 in) ± 12 mm (0.47 in)
The Z height measurement determines the proper ride height for the front end of the vehicle. Vehicles equipped with torsion bars use an adjusting
arm to adjust the Z height. Vehicles without torsion bars have no adjustment and may require replacement of suspension components.
Important: All dimensions are measured vertical to the ground. Cross vehicle Z heights should be within 24 mm (0.9 in).
D Height Measurement
All ................................................................................................................................................................................ 110 mm (4.33 in) ± 4 mm 0.16 in)
The D height measurement determines the proper ride height for the rear end of the vehicle. There is no adjustment procedure. Repair may require
replacement of suspension components.
Important: All dimensions are measured vertical to the ground. Cross vehicle D heights should be within 12 mm (0.5 in) for vehicles equipped
with coil springs. Vehicles equipped with air suspension should be within 8 mm (0.3 in).
