9-7X V8-6.0L (2008)
7. Connect the instrument panel harness connector (1) to the block base.
8. Install the junction block to the block base.
Ensure that the retaining tabs are fully seated.
9. Install the 3 bolts (1) that retain the junction block to the block base.
Tighten the 3 bolts to 3.5 Nm (31 in. lbs.).
10. Install the BCM to the rear electrical center. Refer toBody Control Module Replacement (See: Body and Frame/Body Control Systems/Body
Control Module/Service and Repair/Body Control Module Replacement).
11. Install the battery feed terminal nut (2) to the junction block.
Tighten the battery feed terminal nut to 10 Nm (88 in. lbs.).
12. Install the rear electrical center cover.
13. Position the left second row seat to a passenger position.
14. Connect the battery negative cable. Refer toBattery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
