9-7X V8-6.0L (2008)
Notice: In order to avoid damage to the circuit board, do NOT over-tighten the thumb screws. Using your fingers, apply only a light pressure.
3. Connect the 2 electrical connectors.
Tighten the module thumb screw to a maximum of 0.2 Nm (2 in. lbs.).
4. Install the protective cover to the module.
5. Position the right rear seat bottom to a passenger position.
Important: After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to
reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the
keypad will NOT reset this version of the OnStar(R) system. This action will cause a DTC to set.
6. For Programming and set up, Refer to Control Module References (See: Testing and Inspection/Programming and Relearning/Control Module
References).
