9-7X V8-6.0L (2008)
Impact Sensor: Service and Repair
Inflatable Restraint Vehicle Rollover Sensor Replacement
Inflatable Restraint Vehicle Rollover Sensor Replacement
Removal Procedure
Caution: Refer to SIR Caution (See: Service Precautions/Technician Safety Information/SIR Caution).
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair).
2. Fold back the rear carpet in order to gain access to the sensor. Refer to Rear Floor Panel Carpet Replacement (See: Body and Frame/Interior
Moulding / Trim/Carpet/Service and Repair/Removal and Replacement/Rear Floor Panel Carpet Replacement).
3. Disconnect the electrical connector.
4. Remove the nuts securing the rollover sensor to the floor panel.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
1. Install the nuts securing the rollover sensor to the floor panel.
Tighten the screws to 10 Nm (88 in. lbs.).
2. Connect the electrical connectors.
3. Install the rear carpet. Refer to Rear Floor Panel Carpet Replacement (See: Body and Frame/Interior Moulding / Trim/Carpet/Service and
Repair/Removal and Replacement/Rear Floor Panel Carpet Replacement).
4. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Air Bag(s) Arming and Disarming/Service and Repair).