9-7X V8-6.0L (2008)
Impact Sensor: Service and Repair
Inflatable Restraint Front End Sensor Replacement
Inflatable Restraint Front End Sensor Replacement
Removal Procedure
Caution: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely
fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
Caution: Refer to SIR Caution (See: Restraint Systems/Service Precautions/Technician Safety Information/SIR Caution).
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
2. Remove the grille. Refer to Grille Replacement (See: Body and Frame/Grille/Service and Repair).
3. Remove the headlamp wire harness from the retaining clip (1).
4. Raise and support the headlamp wire harness (1) to gain access to the front end sensor.
5. Loosen the bolts (1) retaining the sensor to the frame.
6. Remove the sensor assembly from the frame (1).
