9-7X V8-6.0L (2008)
7. Press down the retainer (1) until fully seated in the depression.
8. Inspect for proper tumbler installation:
1. Hold the spring retainer (2) in position.
2. Insert the key (1) into the cylinder.
3. The side bar (3) should drop down flush with the cylinder diameter if properly installed.
4. Disassemble and assemble properly as needed.
9. Remove the key.
10. Secure the cylinder in the J 41340.
1. Inspect that the spring retainer is facing up and positioned directly under the punch slots.
2. Push the cylinder into the J 41340 until butted with the cylinder bezel.
3. Tighten the holding screw.
11. Stake the bezel end of the retainer in place:
1. Hold the flat side of the punch, part of J 41340, squarely against the face of the cylinder bezel.
2. Stake the lock cylinder metal over the retainer corners.
