9-7X V8-6.0L (2008)
Front Steering Knuckle: Service and Repair
Steering Knuckle Replacement (RWD)
Steering Knuckle Replacement (RWD)
Tools Required
*
J 24319-B Steering Linkage and Tie Rod Puller
*
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
3. Remove the wheel hub and bearing. Refer to Front Wheel Hub, Bearing, and Seal Replacement (RWD) (See: Wheel Hub/Service and
Repair/Front Wheel Hub, Bearing, and Seal Replacement (RWD))Front Wheel Hub, Bearing, and Seal Replacement (4WD) (See: Wheel
Hub/Service and Repair/Front Wheel Hub, Bearing, and Seal Replacement (4WD)).
4. Remove and discard the outer tie rod retaining nut.
5. Disconnect the outer tie rod from the steering knuckle using J 24319-B.
6. Remove the brake hose bracket retaining bolts.
7. Remove the brake hose bracket from the steering knuckle.