9-7X V8-6.0L (2008)
10. Notice: Refer to Fastener in Service Precautions.
Important: Do not remove the air spring level sensor locating pin until the air spring level sensor has been properly aligned and the proper D
height has been measured and maintained. Refer to Trim Height Specifications.
Tighten the air spring level sensor to the frame mounting bolts.
Tighten the air spring level sensor to the frame mounting bolts to 8 Nm (71 inch lbs.).
11. Notice: Failure to remove the air suspension auto level control sensor locating pin before the rear axle support is removed will cause damage to
the air suspension auto level control sensor.
Remove the air spring level sensor locating pin.
12. Important: Check the air supply lines for deep scores or cuts. If the air supply lines are damaged the lines must be replaced.
