9-7X V8-6.0L (2008)
1. Install the air spring level sensor link to the upper control arm.
2. Notice: Refer to Fastener in Service Precautions.
Important: Do not remove the air spring level sensor locating pin until the air spring level sensor has been properly aligned and the proper D
height has been measured and maintained. Refer to Trim Height Specifications.
Install the air spring level sensor to the frame mounting bolts.
Tighten the air spring level sensor to the frame mounting bolts to 8 Nm (71 inch lbs.).
3. Connect the air spring level sensor electrical connector.
4. Notice: Failure to remove the air suspension auto level control sensor locating pin before the rear axle support is removed will cause damage to
the air suspension auto level control sensor.
