9-7X V8-6.0L (2008)
1. Install the propeller shaft in the transfer case.
2. Align the reference marks made during removal.
Important: Ensure that the propeller shaft assembly is fully engaged into the slip yoke. The retaining ring will produce a snapping noise
when the shaft is properly engaged.
3. Install the propeller shaft to the front axle pinion yoke.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
4. Install the yoke retainers and the bolts.
Tighten the front propeller shaft yoke clamp bolts to 20 Nm (15 ft. lbs.).
5. Install the steering gear crossmember. Refer to Rear Steering Gear Crossmember Replacement (See: Body and
Frame/Frame/Cross-Member/Service and Repair/Rear Steering Gear Crossmember Replacement).
6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
