9-7X V8-6.0L (2008)
17. Pack the boot and housing with the grease supplied in the kit. The amount of grease supplied in this kit has been pre-measured for this application.
18. Place the large retaining clamp (2) on the boot.
19. Place the housing (1) and the new trilobal tripot bushing over the spider assembly (3).
20. Install the boot onto the trilobal tripot bushing.
21. Inspect the inboard stroke position (see diagram).
*
For male tripot housing assembly: dimension a = 280 mm (11 in).
*
For female tripot housing assembly: dimension b = 228 mm (9 in).