9-7X V8-6.0L (2008)
2. Align the rear output shaft seal.
3. Using the J 37668-A, install the rear output shaft seal.
4. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Rear Propeller Shaft Replacement).
5. Inspect the transfer case fluid level. Refer to Transfer Case Fluid Replacement (See: Service and Repair/Removal and Replacement/NVG
126-NP4 - Transfer Case/Transfer Case Fluid Replacement).
6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
Input Shaft Seal Replacement
Input Shaft Seal Replacement
Tools Required
J 42738 Seal Installer
Removal Procedure