9-7X V8-6.0L (2008)
3. Properly align the keyway of the rotary position sensor with the motor/encoder shaft as indicated by the center reference line shown in the graphic.
4. Ensure that the hex on the rotary position sensor (2) fits in the hex of the motor/encoder housing (3).
5. Install the motor/encoder baseplate/gasket (1).
Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper
installation.
6. Install the motor/encoder to the transfer case.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice)
7. Install motor/encoder mounting bolts to the transfer case.
Tighten the bolts to 16 Nm (12 ft. lbs.).
