900 L4-1985cc 2.0L (1982)
3.
If leakage still exists after the evaporator location has been checked, the evaporator must be removed and the drain hose fitting and the two halves
of the housing must be sealed with Strip-Calk.
NOTE:
Pay particular attention to the fitting for the drain hose. Movement of this fitting during operation of the vehicle will allow water to leak
by, thus it must be sealed well.
Time to perform this is approximately 2.2 hours. This includes Operation #91060 to R & R evaporator and 0.5 hour straight time to seal the
housing.
Warranty Information:
Use Failure Code:
85414-05-4-XX-05. Time allowed is as included in the above three repairs. (Substitute correct type of coverage code for XX.)
