900 L4-1985cc 2.0L DOHC (1986)
Tools required:
A.
1/16" and 3/16" Drill Bit
B.
T-10 and T-25 Torx Drivers
C.
#2 Phillips Head Screw Driver
D.
8 mm and 10 mm Socket or Wrenches
E.
Spray Undercoating
F.
Small Round File
1.
Support car on a lift or jack stands and remove both rear wheels.
2.
Remove the end pieces from the rear of both wheel housings (4 screws each).
3.
Using a 3/16" drill bit, drill out the (2) two rivets in each of the rear wheel housing.
4.
Install the protective strips on the inner edge of each rear wheel housing (the protective strips are standard equipment on most models).
5.
Remove the small screws (T-10 torx head) securing the top corners of the bumper extensions to the wheel housings.