900 L4-1985cc 2.0L DOHC (1986)
FIGURE 2
3.
Rotate the oil cooler as shown in fig. 2 and at the same time loosen the oil cooler hose fitting and rotate 15~ +/- 3~ closer to the engine. This
will give more clearance at the fan support. Re-tighten the hose. There should be no binding of the hose. Start the engine and check for leaks.
Check your clearance and proceed to step 4 if inadequate.
FIGURE 3
4.
Remove the radiator fan and cut away the fan support as shown in fig. 3. Replace the radiator fan.
Warranty Information:
If the clearance is less than 1/8", use Failure Code 26134-07-0-06/01-05. For steps 1, 2, and 3, labor allowance is 0.3 hour
(enter as Straight Time). If step 4 is necessary, add Labor Operation #26251 for 0.5 hour.
