900 L4-1985cc 2.0L DOHC Turbo EFI (1985)
2.
Drill out the (5) rivets in each of the rear wheel openings with a 3/16" bit.
3.
Remove protective strips from the lower rear edge of the wheel openings and trim as shown in diagram (where applicable). Reinstall inner part of
protective strips.
NOTE:
The area exposed by the removal of protective strip should be sprayed with undercoating (both sides).
4.
It may be necessary to trim the lower rear end of the wheel opening molding so that it does not extend past the end of wheel opening.
5.
Locate backing plate over the inner screw hole with the thick edge facing the outer edge of the wheel opening. Install mud flap with the
(3)
lower screws.
NOTE:
Put the screw through the upper hole in each plate. Plate is mounted behind mud flap